Chapter XXXVII.—The Steam Engine

The high pressure steam engine, in whatever form it exists, consists of a frame or bed plate carrying two distinct mechanisms, first, the driving or power-transmitting mechanism, and second, the valve gear or valve motion, and to these are added such other mechanisms as the nature of the duty the engine is to perform may require.

The most prominent of these additional mechanisms is a governor for regulating the speed at which the engine is to run; nearly all steam engines require a governor in some form or other, while for electric lighting and some other purposes it constitutes the main feature in the design of the engine.

In a locomotive the air brake and the sand box are elements not found in other engines.

In a jet condensing engine, the condenser and injection water, or condensing water mechanism, is a part of the engine.

In a surface condensing engine, the air pumps and circulating pumps are a part of the engine.

In marine engines there are mechanisms for turning the engine around when no steam is up; for moving the reversing gear quickly, and for varying the point of cut off, and therefore the amount of expansion, and various other and minor mechanisms.

Referring now to the simplest form of high pressure stationary steam engine, such as represented in Figs. 3293, 3294, and 3295, its valve gear or valve motion consists of the eccentric and its strap, the eccentric rod, the valve rod guide a, the valve rod or valve spindle, and the valve v, these parts controlling the admission of steam to one side of the piston, and the exhaust from the other.

The piston, piston rod, cross head, connecting rod, crank, crank shaft, main shaft or driving shaft, and the fly wheel constitute the driving or power-transmitting mechanism.

The steam side of the piston is that against which the steam is pressing, as side s in Fig. 3295. The exhaust side, e, of the piston is that on which the steam is passing out or exhausting.

The governor for a common D valve engine regulates the engine speed by varying the opening in the bore of the pipe through which the steam passes from the boiler to the steam chest, leaving a wider opening in proportion as the engine runs slower, and reducing the opening when the engine runs faster. Assuming the engine to be running at its slowest, or its load to be so great that a full supply of steam is required in order to keep the engine up to its proper speed, and the governor will be open at its widest, so that all the further action the governor can have is to reduce the steam pipe opening, and thus cause the pressure in the steam chest to be less than that in the steam pipe.

This action is called wire-drawing the steam, and the governor is called a throttling governor.

An engine bed or bed plate is a frame that is seated or bedded to its foundation along its whole length.

An engine frame is seated to its foundations at two or more places, but not continuously throughout its length.